The OPARA service was recently upgraded to a new technical platform. You are visiting the outdated OPARA website. Please use https://opara.zih.tu-dresden.de/ for new data submissions. Previously stored data will be migrated in near future and then the old version of OPARA will finally be shut down. Existing DOIs for data publications remain valid.
Auflistung Bereich Ingenieurwissenschaften nach Autor "dfg"
Anzeige der Treffer 1-7 von 7
-
Computed tomography data of different resolution of expanded polypropylene foams of different density
Preiß, Gina; Löffler, Markus; Koch, Ilja; Geske, Vinzenz; Danczak, Marek; Gude, Maik (Technische Universität DresdenInstitute of Lightweight Engineering and Polymer Technology - ILK, 2022)In this work, the morphology of three EPP bead foams with closed cells and different densities is studied using x-ray computed tomography. The specimens of 10 mm diameter and 10 mm length were cut from steam-chest-molded ... -
Experimental analysis of residual stress evolution under cyclic mechanical loading in 42CrMo4+QT (1.7225) including parametrization data
Schneider, Tom; Gibmeier, Jens; Kästner, Markus (Technische Universität Dresden, 2024)This data set contains various results from (cyclic) tests with 42CrMo4+QT/SAE4140. The first part contains the results of cyclic 4-point bending tests on cuboid specimens. They were used to measure the residual stress. ... -
Experimental characterization of fatigue behavior of 42CrMo4+QT material specimens and cross-rolled components
Schneider, Tom; Ellmer, Franz; Guilleaume, Christina; Hantschke, Peter; Brosius, Alexander; Kästner, Markus (Technische Universität Dresden, 2023)This dataset provides a cyclic material characterization from cyclic tests of material specimen made of 42CrMo4+QT. In addition, fatigue life data are included for cross-rolled components produced with different process ... -
Forming and cutting at high strain rates Part 3: Deep drawing
Tulke, Marc; Galiev, Elmar (Technische Universität DresdenFraunhofer Institute for Machine Tools and Forming Technology IWU, 2023)Based on the material properties determined in "Forming and cutting at high strain rates Part 1" and "Part 2", the applicability of the methodology and the material characteristics are verified using a deep drawing process ... -
Forming and cutting at high strain rates Part 4: High-speed blanking
Galiev, Elmar; Tulke, Marc (Technische Universität DresdenFraunhofer Institute for Machine Tools and Forming Technology IWU, 2023)Based on the material properties determined in "Forming and cutting at high strain rates Part 1" and "Part 2", the applicability of the methodology and the material characteristics are verified using a high-spped blanking ... -
Forming at high strain rates Part 2: Analysis of adiabatic heating based on tensile tests of DC06
Tulke, Marc; Galiev, Elmar (Technische Universität DresdenFraunhofer Institute for Machine Tools and Forming Technology IWU, 2023)In high strain rate forming processes two superposing and opposing effects influence the flow stress of the material: strain rate hardening and thermal softening due to adiabatic heating. The presented FE-model and ... -
Videodateien
Schuldt, Stefan (Technische Universität Dresden, 2018)